Summary
GEPRC ELRS Nano receiver is a new generation remote control system developed based on the ExpressLRS open source project. ExpressLRS sets new standartds for long-range connection, low latency and maximum refresh rate of 500Hz.
GEPRC ELRS Nano receivers are available in 915/868MHz and 2.4GHz versions with maximum refresh rate of 500Hz and can be used with GEPRC ELRS-series products or other ELRS-compatible devices.
Specifications
Size: 16.8mm*10mm
Weight: 0.6g(receiver only)
Frequency band: 915MHz FCC/868MHz EU/2.4GHz ISM
Input voltage：5V
Antenna connector: ipex1
Feature
1. Small size
2. 0.6g weight
3. WIFI Upgrade firmware
4. ELRS open source project, remote control
5.The operation is simple
Package Included
1 x Receiver
1 x T antenna
2 x Heat shrink tube
4 x Silicone cable（black, red, yellow, green）
1 x Pin (4pin)
1 x Instruction manual
ELRS Nano Receiver Diagram
LED Status indication
Instructions
ELRS Nano receiver and FC connection diagram:
Open Betaflight Configurator, go to “Ports”tab and enable the corresponding UART as a Serial Rx (e.g. UART2 as shown below). Save and restart.
On the“Configuration”tab, click on“Serial-based receiver”on the“Receiver”panel, and select “CRSF”
Binding
1. The receiver is powered on and off for three consecutive times (within an interval of 1 second);
2. Receiver’s LED doing double flashing, indicating that the receiver has entered the binding mode;
3. Make the RF Tx module or radio transmitter enter binding status. Once the LED status changes to solid light, the binding is successful.
Reviews
There are no reviews yet.